A. Du, « relatif au contrôle d'étanchéité des éléments assurant le confinement des fluides frigorigènes utilisés dans les équipements frigorifiques et climatiques », Journal Officiel De La République Française, vol.8, 2007.

B. Margaret and B. , System Performance Characteristics of a Helical Rotary Screw Air-Cooled Chiller Operating Over a Range of Refrigerant Charge Conditions, ASHRAE Transactions, p.4207, 1998.

B. Bansal, H. Müller-steinhagen, and X. D. Chen, Performance of plate heat exchangers during calcium sulphate fouling ??? investigation with an in-line filter, Chemical Engineering and Processing: Process Intensification, vol.39, issue.6, pp.507-519, 2000.
DOI : 10.1016/S0255-2701(00)00098-2

T. R. Bott, Fouling of heat exchangers, 1995.

B. Mark, S. Braun-james, and E. , Evaluating the Performance of a Fault Detection and Diagnostic System for Vapor Compression Equipment, ASHRAE Transaction, pp.4269-99, 1999.

B. Mark, S. Braun-james, and E. , Common Faults and Their Impacts for Rooftop Air Conditioners, HVAC&R Research, vol.4, pp.3-4268, 1998.

C. California, Residential Compliance Manual For California's 2005 Energy Efficiency Standards, Publication Number: CEC-400-2005-005-CMF, 2005.

B. Chen and J. E. Braun, Simple Rule-Based Methods for Fault Detection and Diagnostics Applied to Packaged Air Conditioners, ASHRAE Winter Meeting, pp.847-857, 2001.

J. Choi and Y. Kimb, Influence of the expansion device on the performance of a heat pump using R407C under a range of charging conditions, International Journal of Refrigeration, vol.27, issue.4, pp.378-384, 2004.
DOI : 10.1016/j.ijrefrig.2003.12.002

M. C. Comstock, . J. Braun, and E. A. Groll, The Sensitivity of Chiller Performance to Common Faults, HVAC & R Research, 2001.
DOI : 10.1080/10789669.2001.10391274

M. C. Comstock, J. E. Braun, and E. A. Groll, A Survey of Common Faults for Chillers, ASHRAE Winter Meeting, pp.819-825, 2002.

J. M. Alessandrini, A. Bolher, E. Fleury, D. Marchio, J. R. Millet et al., Etude de la sensibilité et validation in situ de la méthode Consoclim : Rapport Final, Consoclim, 2002.

C. N. Davies, Air Filtration, 1973.

R. W. Dehausse and J. W. Thomas, Theory of a diffusion battery" Oak Ridge National Laboratory ORNL-1413, 1952.

B. P. Dougherty, J. J. Filliben, and A. I. Avilés, Central Air Conditioner Test Procedure Public Workshop: A Technical Discussion on New Defaults for CCD, National Institute of Standards and Technology " http://www.eere.energy.gov/ ECODESIGNPreparatory study on the environmental performance of residential room conditioning appliances-Draft report of Task 4 Technical Analysis of existing products, 2002.

S. K. Fischer and C. K. Rice, The Oak Ridge Heat Pump Models: I. A Steady-State Computer Design Model for Air-to-Air Heat Pumps, 1983.

I. N. Grace, D. Datta, and S. A. Tassou, Sensitivity of refrigeration system performance to charge levels and parameters for on-line leak detection, Applied Thermal Engineering, vol.25, issue.4, pp.557-566, 2005.
DOI : 10.1016/j.applthermaleng.2004.07.008

R. Haghighi-khoshkhoo and F. M. Mccluskey, Air-Side Fouling of Compact Heat Exchangers for Discrete Particle Size Ranges, Heat Transfer Engineering, vol.89, issue.1, 2007.
DOI : 10.1016/S0012-365X(97)00050-2

W. C. Hinds, Aerosol technology : Properties, behavior, and measurement of airborne particles, 1999.

R. Israel and D. E. Rosner, Use of a Generalized Stokes Number to Determine the Aerodynamic Capture Efficiency of Non-Stokesian Particles from a Compressible Gas Flow, Aerosol Science and Technology, vol.18, issue.1, pp.45-51, 1983.
DOI : 10.1080/02786828308958612

A. Johansson and P. Lundqvist, A method to estimate the circulated composition in refrigeration and heat pump systems using zeotropic refrigerant mixtures, International Journal of Refrigeration, vol.24, issue.8, pp.798-808, 2001.
DOI : 10.1016/S0140-7007(00)00061-X

T. Kho, H. U. Zettler, H. Müller-steinhagen, and D. Hughes, Effect of Flow Distribution on Scale Formation in Plate and Frame Heat Exchangers, Chemical Engineering Research and Design, vol.75, issue.7, pp.635-640, 1997.
DOI : 10.1205/026387697524245

N. H. Kim, B. Youn, and W. R. , Heat Transfer and Friction Correlations for Plain Fin-and- Tube Heat Exchangers, 11th Int. Heat Transfer Conf, vol.6, pp.209-213, 1998.

E. Kinab, A. Fau, D. Marchio, and P. Rivière, 2007 « Model of a Reversible Heat Pump for Part Load Energy Based Optimization Design " Clima, Proceedings, 2007.

M. Krarti, D. Marchio, I. Arditi, and C. Carretero, Guide technique d'audit énergétique des bâtiments, 2001.

H. Landahl and K. Hermann, Sampling of liquid aerosols by wires, cylinders, and slides, and the efficiency of impaction of the droplets, Journal of Colloid Science, vol.4, issue.2, pp.103-136, 1949.
DOI : 10.1016/0095-8522(49)90038-0

K. W. Lee and B. Y. Liu, Theoretical Study of Aerosol Filtration by Fibrous Filters, Aerosol Science and Technology, vol.5, issue.2, pp.147-161, 1982.
DOI : 10.1080/02786828208958584

. Lestari, . Puji, A. K. Oskouieb, N. Kenneth, and E. , Size distribution and dry deposition of particulate mass, sulfate and nitrate in an urban area, Atmospheric Environment, vol.37, issue.18, pp.2507-2516, 2003.
DOI : 10.1016/S1352-2310(03)00151-1

G. A. Longo, A. Gasparella, and R. Sartori, Experimental heat transfer coefficients during refrigerant vaporisation and condensation inside herringbone-type plate heat exchangers with enhanced surfaces, International Journal of Heat and Mass Transfer, vol.47, issue.19-20, pp.4125-4136, 2004.
DOI : 10.1016/j.ijheatmasstransfer.2004.05.001

M. Ian, B. D. , M. John, W. Beckman-william, and A. , Fault Detection and Diagnosis in Chillers?Part I: Model Development and Application, p.4, 1998.

G. Pak-bock-choon, A. Eckhard, and E. Braun-james, Impact of fouling in cleaning on plate fin and spine fin heat exchanger performance, ASHRAE Transaction Winter meeting, pp.5-6, 2005.

C. B. Panchal and T. J. Rabas, Fouling Characteristics of Compact Heat Exchangers and Enhanced Tubes, International Conference on Compact Heat Exchangers and Enhancement Technology for the Process Industries, 1999.

D. Parker, J. Sherwin, R. Raustad, and D. Shirey, Impact of Evaporator Coil Air Flow in Residential Air Conditioning Systems, ASHRAE Annual Meeting, 1997.

J. Phelan, M. J. Brandemuehl, and M. Krarti, In-situ performance Testing of Chillers for Energy Analysis, ASHRAE Transaction, vol.103, issue.1 4040, pp.290-302, 1997.

C. K. Rice, The ORNL Modulating Heat Pump Design Tool -Mark IV User's Guide, 1991.
DOI : 10.2172/814355

C. K. Rice, ORNL Heat Pump Design Model: Description of Heat Pump Specification Data - Mark V, Version 95D -Update Notes, 1996.

P. Rivière, Performances saisonnières des groupes de production d'eau glacée, 2004.

J. A. Siegel, M. Stylianou, and D. Nikanpour, Dissertation: Particulate Fouling of HVAC Heat Exchangers Performance monitoring, fault detection, and diagnosis of reciprocating chillers, ASHRAE Transactions, vol.102, issue.1, pp.699-706, 1996.

D. Thomas, P. Penicot, P. Contal, D. Leclerc, and . J. Vendel, Clogging of fibrous filters by solid aerosol particles Experimental and modelling study, Chemical Engineering Science, vol.56, issue.11, pp.3549-3561, 2001.
DOI : 10.1016/S0009-2509(01)00041-0

C. C. Wang, Y. J. Chang, Y. J. Hsieh, and Y. T. Lin, Sensible heat and friction characteristics of plate fin-and-tube heat exchangers having plane fins, International Journal of Refrigeration, vol.19, issue.4, pp.223-230, 1996.
DOI : 10.1016/0140-7007(96)00021-7

C. C. Wang, P. Y. Chen, and J. Y. Jang, HEAT TRANSFER AND FRICTION CHARACTERISTICS OF CONVEX-LOUVER FIN-AND-TUBE HEAT EXCHANGERS, Experimental Heat Transfer, vol.84, issue.4, pp.61-78, 1996.
DOI : 10.1016/0894-1777(94)90008-6

M. Ward and J. A. Siegel, Modeling Filter Bypass: Impact on Filter Efficiency, ASHRAE Transactions, vol.111, issue.2, pp.1091-1100, 2005.

K. T. Whitby, W. E. Clark, V. A. Marple, G. M. Sverdrup, G. J. Sem et al., Characterization of California aerosols???I. Size distributions of freeway aerosol, Atmospheric Environment (1967), vol.9, issue.5, pp.463-482, 1975.
DOI : 10.1016/0004-6981(75)90107-9

S. M. Zivi, Estimation of Steady-State Steam Void-Fraction by Means of the Principle of Minimum Entropy Production, Journal of Heat Transfer, vol.86, issue.2, pp.247-52, 1964.
DOI : 10.1115/1.3687113