J. Sarkar, S. Bhattacharyya, and M. R. Gopal, Indian institute of technology Transcritical CO 2 heat pump systems: exergy analysis including heat transfer and fluid flow effects, pp.46-2053, 2004.

J. Yang, Y. T. Ma, M. X. Li, and H. Q. Guan, Exergy analysis of transcritical carbon dioxide refrigeration cycle with an expander, Energy, vol.30, issue.7, pp.1162-1175, 2005.
DOI : 10.1016/j.energy.2004.08.007

S. Ntnu, . Trondheim, and . Norway, Major design issues for compact interior heat exchangers, 2004.

A. Fartaj, S. David, W. W. Ting, and . Yang, Second law analysis of the transcritical CO 2 refrigeration cycle, pp.45-2269, 2004.

H. Chen, Z. Liu, and . Chen, Experimental analysis of a CO 2 automotive air conditioning system " . , Institute of refrigeration and Cryogenics Engineering, 2005.

T. Takahashi, Development of Carbon dioxide applied refrigeration system " . Calsonickansei Corporation; SAE automotive alternate refrigerant system, pp.11-13, 2000.

H. Hammer and J. Wertenbach, Carbon dioxide R-744 as supplementary heating device " . Engineering conference, 2000.

J. Frohling, CO 2 as refrigerant for A/C and heat pump operation, 2000.

I. Bell, Performance increase of carbon dioxide refrigeration cycle with the addition of parallel compression economization, 2005.

J. Wilhelm-tegethoff, T. Köhler, N. Försterling, T. Lemke, . Gmbh et al., Expansion device specification using steady state and transient simulation " .VDA-Wintermeeting, 2004.

A. Pearson, Carbon dioxide???new uses for an old refrigerant, International Journal of Refrigeration, vol.28, issue.8, pp.1140-1148, 2005.
DOI : 10.1016/j.ijrefrig.2005.09.005

R. Alexis and E. D. Rogdakis, The effect of operating conditions on the performance of a supersonic ejector for refrigeration A verification study of steam-ejector refrigeration model, International journal of refrigeration Applied Thermal Engineering, vol.27, issue.23, pp.974-984, 2003.

A. and E. K. Karayiannis, A solar ejector cooling system using refrigerant R134a in the Athens area, Renewable Energy, vol.30, pp.1457-1469, 2005.

A. Hany, S. M. Ansary, and . Jeter, Numerical and experimental analysis of single-phase and two-phase flow in ejectors, 2004.

P. Aidoun, Y. Desevaux, and . Mercadier, Numerical and experimental investigations on supersonic ejectors (CFD modelisation), Zine, pp.56-70, 2005.

B. J. Chang and . Huang, Empirical correlation for ejector design, International Journal of Refrigeration, vol.22, pp.379-388, 1999.

S. Chu-04a-]-kanjanapon-chunnanond and . Aphornratana, Ejectors: applications in refrigeration technology, Renewable and Sustainable Energy Reviews, vol.8, issue.2, pp.129-155, 2004.
DOI : 10.1016/j.rser.2003.10.001

S. Chu-04b-]-kanjanapon-chunnanond and . Aphornratana, An experimental investigation of a steam ejector refrigerator: the analysis of the pressure profile along the ejector, Applied Thermal Engineering, vol.24, issue.2-3, pp.311-322, 2004.
DOI : 10.1016/j.applthermaleng.2003.07.003

K. Cizungu, M. Groll, and Z. G. Ling, Modelling and optimization of two-phase ejectors for cooling systems, Applied Thermal Engineering, vol.25, issue.13, pp.1979-1994, 2005.
DOI : 10.1016/j.applthermaleng.2004.11.014

A. R. Dorants and . Lallemand, Influence de la nature des fluides, purs ou en m??langes non-az??otropiques, sur les performances d'une machine de climatisation ?? ??jecto-compresseur, International Journal of Refrigeration, vol.18, issue.1, pp.21-30, 1995.
DOI : 10.1016/0140-7007(94)P3708-9

I. W. Eames, A new prescription for the design of supersonic jet-pumps: the constant rate of momentum change method, Applied Thermal Engineering, vol.22, issue.2, pp.121-131, 2002.
DOI : 10.1016/S1359-4311(01)00079-5

P. Asinari, Numerical prediction of turbulent convective heat transfer in mini/micro channels for carbon dioxide at supercritical pressure, International Journal of Heat and Mass Transfer, vol.48, issue.18, pp.3864-3879, 2005.
DOI : 10.1016/j.ijheatmasstransfer.2005.03.028

N. Kattan, J. R. Thome, and D. Favrat, Flow Boiling in Horizontal Tubes: Part 1???Development of a Diabatic Two-Phase Flow Pattern Map, Journal of Heat Transfer, vol.120, issue.1, pp.140-147, 1998.
DOI : 10.1115/1.2830037

N. Kattan, J. R. Tome, and D. Favrat, Flow Boiling in Horizontal Tubes: Part 2???New Heat Transfer Data for Five Refrigerants, Journal of Heat Transfer, vol.120, issue.1, pp.148-155, 1998.
DOI : 10.1115/1.2830038

N. Kattan, J. R. Thome, and D. Favrat, Flow Boiling in Horizontal Tubes: Part 3???Development of a New Heat Transfer Model Based on Flow Pattern, Journal of Heat Transfer, vol.120, issue.1, pp.156-165, 1998.
DOI : 10.1115/1.2830039

P. A. Kew and K. Cornwell, Correlations for the prediction of boiling heat transfer in small-diameter channels, Applied Thermal Engineering, vol.17, issue.8-10, pp.705-715, 1997.
DOI : 10.1016/S1359-4311(96)00071-3

M. V. Peeters, G. F. Fernandez-cid, W. J. Woerlee, G. J. Veugelers, and . Witkamp, The influence of variable physical properties and buoyancy on heat exchanger design for near-and supercritical conditions, J. of Supercritical Fluids, vol.34, pp.99-105, 2005.

T. S. Liao and . Zhao, An experimental investigation of convection heat transfer to supercritical carbon dioxide in miniature tubes, International Journal of Heat and Mass Transfer, vol.45, issue.25, pp.5025-5034, 2002.
DOI : 10.1016/S0017-9310(02)00206-5

P. Jacques, Convection thermique et massique: Nombre de Nusselt: partie 1 " ; Technique de l'ingénieur, pp.206-207

I. L. Pioro, H. F. Khartabil, and R. B. Duffey, Heat transfer to supercritical fluids flowing in channels???empirical correlations (survey), Nuclear Engineering and Design, vol.230, issue.1-3, pp.69-91, 2004.
DOI : 10.1016/j.nucengdes.2003.10.010

S. S. Pitla, D. M. Robinson, A. Zingerli, E. A. Groll, and S. Ramadhayani, Heat transfer and pressure drop characteristics during in tube gas cooling of supercritical carbon dioxide " ; Ray W, 2000.

S. S. Pitla, E. A. Groll, and S. Ramadhyani, New correlation to predict the heat transfer coefficient during in-tube cooling of turbulent supercritical CO2, International Journal of Refrigeration, vol.25, issue.7, pp.887-895, 2002.
DOI : 10.1016/S0140-7007(01)00098-6

R. Rieberer, as working fluid for heat pumps An experimental study on heat transfer and pressure drop characteristics of carbon dioxide during gas cooling process in a horizontal tube, International Journal of Refrigeration, vol.29, issue.2, pp.539-546, 1998.

J. R. Thome, Flow boiling heat transfer to carbon dioxide: general prediction method, International Journal of Refrigeration, vol.27, issue.3, pp.294-301, 2004.
DOI : 10.1016/j.ijrefrig.2003.08.003

J. R. Thome and G. Ribatski, State-of-the-art of two-phase flow and flow boiling heat transfer and pressure drop of CO2 in macro- and micro-channels, International Journal of Refrigeration, vol.28, issue.8, pp.1149-1168, 2005.
DOI : 10.1016/j.ijrefrig.2005.07.005

T. Leszek-wojtan, J. R. Ursenbacher, and . Thome, Investigation of flow boiling in horizontal tubes: Part I???A new diabatic two-phase flow pattern map, International Journal of Heat and Mass Transfer, vol.48, issue.14, pp.2955-2969, 2005.
DOI : 10.1016/j.ijheatmasstransfer.2004.12.012

T. Leszek-wojtan, J. R. Ursenbacher, and . Thome, Investigation of flow boiling in horizontal tubes: Part II???Development of a new heat transfer model for stratified-wavy, dryout and mist flow regimes, International Journal of Heat and Mass Transfer, vol.48, issue.14, pp.2970-2985, 2005.
DOI : 10.1016/j.ijheatmasstransfer.2004.12.013

C. W. Jian-min-yin, P. S. Bullard, and . Hrnjak, R-744 gas cooler model development and validation, International Journal of Refrigeration, vol.24, issue.7, pp.692-701, 2001.
DOI : 10.1016/S0140-7007(00)00082-7

J. Seok-ho-yoon, Y. W. Kim, M. Hwang, K. Soo-kim, Y. Minb et al., Heat transfer and pressure drop characteristics during the in-tube cooling process of carbon dioxide in the supercritical region, International Journal of Refrigeration, vol.26, issue.8, pp.857-864, 2003.
DOI : 10.1016/S0140-7007(03)00096-3

E. S. Seok-ho-yoon, Y. W. Cho, M. S. Hwang, K. Kim, Y. Min et al., Characteristics of evaporative heat transfer and pressure drop of carbon dioxide and correlation development, International Journal of Refrigeration, vol.27, issue.2, pp.111-119, 2004.
DOI : 10.1016/j.ijrefrig.2003.08.006

Y. ]-rin-yun, M. S. Kim, Y. Kim, and . Choi, Boiling heat transfer and dryout phenomenon of CO2 in a horizontal smooth tube, International Journal of Heat and Mass Transfer, vol.46, issue.13, pp.2353-2361, 2003.
DOI : 10.1016/S0017-9310(02)00540-9

H. Xin-rong-zhang and . Yamaguchi, Forced convection heat transfer of supercritical CO2 in a horizontal circular tube, J. of Supercritical Fluids, 2006.

. J. References, J. P. Chen, Z. J. Liu, Y. M. Chen, and . Niu, Trans-critical R744 and twophase flow through short tube orifices, International Journal of Thermal Sciences, vol.43, pp.623-630, 2004.

Y. Chen and J. Gu, Non-adiabatic capillary tube flow of carbon dioxide in a novel refrigeration cycle, Applied Thermal Engineering, vol.25, issue.11-12, 2005.
DOI : 10.1016/j.applthermaleng.2004.10.016

K. Martin, R. Rieberer, and J. Hager, Modelling of Short Tube Orifices for CO 2, R111, International Refrigeration and Air Conditioning Conference at Purdue, 2006.