J. De-nos, les outils en carbure sont les plus utilisés dans le domaine de l'usinage, leurs utilisations représentent plus de la moitié de la consommation mondiale des outils de coupe comme l'illustre la Figure 3.1 [Huston et al. 98]. Leur succès est dû à leur faible coût et à leurs bonnes propriétés mécaniques

A. , H. A. Nouari, M. Mansori, and M. , ELInfluence of thermal conductivity on wear when machining titanium alloys, Tribol

A. , J. S. Stephenson, and D. A. , Analytical and Experimental Studies of Drill Temperatures, J. Eng. Ind, vol.116, issue.1, pp.54-60, 1994.

[. A. Ghani, Failure mode analysis of carbide cutting tools used for machining titanium alloy, Ceramics International, vol.39, issue.4, pp.4449-4456, 2013.
DOI : 10.1016/j.ceramint.2012.11.038

B. , Y. Roberts, and W. , The application of a dislocation model to dynamical strain ageing in ?-iron containing interstitial atoms, Acta Metall, vol.19, issue.8, pp.815-823, 1971.

B. , S. K. Alford, and T. L. , Texture formation in Ag thin films: Effect of W?Ti diffusion barriers, J. Appl. Phys, vol.104, issue.10, p.103534, 2008.

. Bhattacharyya, Diffusion wear of cutting tools

E. , E. O. Tang, and S. H. , Surface abuse when machining cast iron (G-17) and nickel-base superalloy (Inconel 718) with ceramic tools

. Fallqvist, Influence of the tool surface micro topography on the tribological characteristics in metal cutting: Part I experimental observations of contact conditions, Wear, vol.298, issue.299, pp.298-29987, 2013.
DOI : 10.1016/j.wear.2012.11.002

N. García, Mechanisms involved in the improvement of Inconel 718 machinability by laser assisted machining (LAM), Int. J. Mach. Tools Manuf, vol.74, 2013.

G. , G. Morel, A. Braham-bouchnak, and T. , Identification of Material Constitutive Laws Representative of Machining Conditions for Two Titanium Alloys: Ti6Al4V and Ti555-3, J. Eng. Mater . Technol, vol.135, issue.3, pp.31002-031002, 2013.

G. , P. Campbell, K. Kosaka, and D. Y. , Hot Workability and Deformation Behavior of TIMETAL 54M

H. , P. D. Kramer, B. M. Von-turkovich, and B. , Tool Wear in Titanium Machining, CIRP Ann. -Manuf. Technol, vol.31, issue.1, pp.75-80, 1982.

. Hatt, Predicting Chemical Wear in Machining Titanium Alloys Via a Novel Low Cost Diffusion Couple Method, Procedia CIRP, vol.45, pp.219-222, 2016.
DOI : 10.1016/j.procir.2016.01.196